We need to connect the ropes with minimum cost.
Join two ropes equal size.
However it works equally well if the ropes are of the same size.
From behind come through the bight and bend back behind it.
An excellent way to join the ends of two ropes especially if the ropes are large.
In comes the sheet bend.
In the diagram below we have two ropes of equal size but the principle is the same.
The sheet bend abok 1431 p 262 or weaver s knot abok 485 p 78 is recommended for joining two ropes of unequal size.
Use a double fisherman knot to join ropes of unequal diameter for multi abseil descents.
The cost to connect two ropes is equal to the sum of their lengths.
There are given n ropes of different lengths we need to connect these ropes into one rope.
The quickest way to connect two ropes is to tie them together.
For critical loads the ends must be left much longer.
The reef knot is used to join two ropes of equal size and which does not come under too much strain.
Bends are knots to tie two ropes together.
It consists basically of 2 overhand knots but care must be taken when putting the knot that the ends are crossed in the opposite way each time that is left over right and right over left and.
It cannot be used to join two ropes of unequal size.
Here is a selection of knots for joining ropes and also some knots where the rope is tied upon itself such as the heaving line knot and the sheep shank the water knot is an excellent knot for use with flat webbing material.
Prepare to tuck the thin rope back under itself.
For example if we are given 4 ropes of lengths 4 3 2 and 6.
We can connect the ropes in the following ways.
Often i find that a piece of cordage just isn t long enough.
The most secure way to connect two ropes is to splice them together.
Pull the end back over the bight and through the first run.
If you are doing a multi abseil retreat using two ropes of equal diameter then the overhand knot is more secure than an figure 8 2.
Its used for joining two different sized ropes together.
When you need to connect two lines you will have to weigh out the pros and cons of each option to decide what is best for you at that moment if you have plenty of time.
Join two ropes of unequal thickness.
The thicker rope must be used for the simple bight as shown.
Go back behind again and repeat.
Curve the thicker rope and poke the thin one up from underneath.
Bring the thin rope back under and around the thick one.
